Gen 3 Insight Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
I saw a post on here about how to go into the maintenance mode, so I tried it today for grins. The dash confirmed I was in maintenance mode, but then alternately displayed the following messages:

Brake Hold System Problem. Apply brake when stopped. See your dealer.

Hill Start Assist Problem. Vehicle may roll upon brake release. See your dealer.

WTF? Why would these messages not be displayed in normal mode, but only in maintenance mode? The general public does not know about maintenance mode.

Is this a real problem? Should I take it into my dealer? I use Brake Hold all the time with no issues.

I have a 2019 with 20,000 miles. TIA.
 
1 - 2 of 2 Posts
Top